VideoSecu Satellite Speaker Mount

They're ok. The mounts ARE holding my speakers. My speakers weigh about 6.5 pounds and have a keyhole bracket. These mounts come with a keyhole adapter that probably works better on most keyhole brackets but for mine, they feel a little sloppy. The mount is equipped with a larger sized threading, probably the 1/4 x 20 thread, and the adapter has two thread sizes. The keyhole adapter consists of two pieces that attach to the other adapter. A nut that goes on first to the larger sized thread(on the adapter) and a special nail head-looking piece that attaches to the end. So, in summary, you have the mount followed by an adapter followed by the keyhole pieces that fit on the adapter. Confused yet? The nail head piece is made up of a larger circle at the cap and a smaller circle on the inside. I'm sure the smaller circle is supposed to slide into most keyhole brackets while the larger circle cap is to hold the speaker. Mine felt sloppy because the smaller circle is too large to slide into the bracket but too small to hold the speaker straight. I fixed this by adding a washer in front of the nut for stability and turning the nail head piece around with the larger circle on the inside and the smaller one on the outside. I hope this helps for those who are looking for the keyhole feature. A few other bits of info: The black paint does tend to come off with the use of tools which you'll probably need and you have to tighten the bracket as much as you can without fear of breaking something. It will make indentations on the plastic ball joint but hopefully you only have to set it once. Setting the angle is probably best done with a friend with better perspective as I went up and down the ladder to adjust the angle until I got them right. (OCD!) Overall, I'm happy with them and feel confident that they're not going to drop my speakers but they do require a little elbow grease.